INSULATE YOUR ATTIC WITH STONEMAN INSULATION

R-value measures insulation’s resistance to heat flow. It can also be referred to as “thermal resistance.” The higher the R-value, the greater the insulating power. All materials having the same R-value, regardless of type, thickness, or weight, are equal in insulating power. The R-value of different insulating materials must be based on test methods established by the American Society of Testing and Materials (ASTM). Don’t forget that R-values are determined by material type, thickness, and installed weight per square foot, not by thickness alone. Insulation helps keep your home cool during the summer months and warm during the winter months.

Insulation saves money, increases home comfort, and protects the environment by reducing energy use. According to the U.S. Department of Energy (DOE), the typical U.S. family spends close to $1,500 each year on energy bills. DOE statistics show that, typically, 44% of a homeowner’s utility bill goes for heating and cooling costs. DOE states that homeowners may be able to reduce their energy bills from 10% to 50% by taking certain steps. One of the major steps is increasing the amount of thermal insulation in their existing homes or purchasing additional insulation when buying new homes.

Unless your home was constructed with special attention to energy efficiency, adding insulation will probably reduce your utility bills. The amount of energy you conserve will depend on several factors: your local climate; the size, shape, and construction of your house; the living habits of your family; the type and efficiency of the heating and cooling systems; and the fuel you use. Energy conserved is money saved, and the annual savings increase when utility rates go up. Insulation upgrades also add to the value of your home.

Fiberglass is made from molten sand or recycled glass and other inorganic materials under highly controlled conditions. Fiberglass is produced in batt, blanket, and loose-fill forms.

Rock and slag wool are manufactured similarly to fiberglass but use natural rock and blast furnace slag as their raw material. Typical forms are loose-fill, blanket, or board types.

Cellulose is a loose-fill made from paper to which flame retardants are added.

Reflective materials are fabricated from aluminum foils with a variety of backings such as polyethylene bubbles and plastic film. Reflective insulations retard the transfer of heat; they can be tested by the same methods as mass insulation and therefore assigned an R-value.

A Radiant Barrier is a building construction material consisting of a low emittance (normally 0.1 or less) surface (usually aluminum foil) bounded by an open air space. Radiant barriers are used for the sole purpose of limiting heat transfer by radiation.